Página 2 | Supertrendstrategy — Indicadores y estrategias

Trend Hunter v4 This strategy follows the Trend Hunter training strategy taught at InvestIshare. Entries are made based predominantly on the price action being above/below the Ichimoku Cloud with the ATR based super trend being used as a trailing stop loss. Additional trend tracking tools can be toggled on / off to improve the wind rate on some time frames, with additional options available to limit entries if certain conditions are met. If you would like access to this indicator, send me a DM on the Investishare Discord in the Trend Hunters channel. The default parameters are set for BTC on the 2 HR time frame

Buy/Sell Signals The indicator is built using Supertrend, RSI, and Ema Crossovers. What is the best way to use the indicator? Indicator can be used in two ways: First : If a signal appears on the chart, you can enter immediately the stoploss is the candle's low with a Small Buffer. Second: you will get good results if you plot additional indicators like as volume, RSI and so on for additional confirmation to get better results

Supertrend Channels [LuxAlgo]The Supertrend is one of the most used indicators by traders when it comes to determining whether the market is up-trending or down-trending. This indicator is displayed as a trailing stop, showing a lower monotonic extremity during up-trends and an upper monotonic extremity during down-trends. Today we propose a channel indicator based on the Supertrend trailing stop using trailing maximas/minimas. Settings Length: Atr length used by the Supertrend indicator. Mult: Multiplicative factor for the Atr used by the Supertrend indicator. Usage The ability of the indicator to show an up-trend or down-trend is the same as the Supertrend, with rising channels when an up-trend is detected by the Supertrend and declining channels when a down-trend is detected by the Supertrend. The look of the channels can remind of the Donchian channels indicator, and as such a similar usage can be appropriate. The extremities can for example be used as supports and resistances. Additionally, the channel's average can be used to filter out noisy variations in the price while keeping a good distance from the price.

Triple Supertrend with EMA and ADX strategy Publishing a strategy that includes adx and ema filter as well Entry: all three Supertrend turns positive. If a filter of ADX and EMA is applied, also check if ADX is above the selected level and close is above EMA Exit: when the first supertrend turns negative opposite for short entries A FIlter is given to take or avoid re-enter on the same side. For example, After a long exit, if the entry condition is satisfied again for long before the short single is triggered it takes re-entry if selected.

[ROXX] Advanced SuperTrend Strategy Hello Trader(s): This is a CTA Strategy for BUY THE TRENDING. Try it in 4-hour Kline. SuperTrend is one of the most common ATR based trailing stop indicators. This is an alternative of the classical Supertrend based on candle close being above/beyond the previous Supertrend level. Hope you'll enjoy it and it will improve your trading making you a better trader ROXX

SuperTrend Optimizer Hello! This indicator attempts to optimize Supertrend parameters. To achieve this, 102 parameter combinations are tested concurrently - the top three performers are listed in descending order. Parameters, Factor: Changes to this parameter shifts the tested factor range. For instance, increasing the factor measure from 3.00 to 3.01 (+0.01) will remove 3.00 from the tested range - this setting controls the lower threshold of the range. The upper threshold, in all instances, is the lower Factor threshold + 3.3 (i.e. 3.0(lower) - 6.3(upper), 4.0(lower) - 7.3(upper), 2.5(lower) - 5.8(upper)) ATR period: Changes to this parameter shifts the tested ATR period range. For instance, increasing the ATR measure from 10 to 11 (+1) will remove 10 from the tested range - this setting controls the lower threshold of the range. The upper threshold, in all instances, is the lower threshold + 2 (i.e. 10(lower) - 12(upper), 11(lower) - 13(upper), 9(lower), - 11(upper)) The Factor parameter is modifiable to any positive decimal number; the ATR parameter is modifiable to any positive integer. Changing either parameter shifts the tested parameter combination range. Both parameters can be changed in the settings, to which you control the lower threshold of the range. If, for instance, you were to change the Factor measurement from 3.0 to 4.1 (+1.1) the 4.0 Factor measurement, and all Factor measures less than 4.0, will be excluded from the performance test. Consequently, a Supertrend test will be performed with a Factor of 4.1 and an ATR period of 10 (default). This test repeats at 0.1 Factor intervals and 1.0 ATR intervals. Therefore, assume you modify the Factor lower threshold to 3.1 and the ATR lower threshold to 10. The indicator will test three Supertrend systems with a Factor of 3.1 and an ATR period of 10.. then 11.. 12, then three systems with a Factor of 3.2 and an ATR period of 10.. then 11.. 12... until (lower Factor threshold + 3.3) and (lower ATR threshold + 2) are tested... which in this example is... a Factor of 6.4 and an ATR period of 12. The tested Factor range and ATR range are displayed in a bottom right table alongside the top performing parameter combinations. Of course, you can change the the lower thresholds, which means you can test numerous Supertrend parameter combinations! However, no greater than 102 parameter combinations will be tested simultaneously; the best performing Supertrend parameters are plotted on the chart automatically. I will be working on this indicator more tomorrow! Let me know if you have questions or anything you would like included! (I of course added something fun in the script. Be sure to try it with bar replay!)

StableF-Main It is combination of Built in Super trend and Adx with take profit uptrend is considered when +dmi is above -dmi and +dmi is above 25 and adx is above 25 and supertrend gives Buy downtrend is considered when -dmi is above +dmi and -dmi is above 25 and adx is above 25 and supertrend give sell use fibo for target by taking as previous swing high and swing low -supertrend crossover is referred as buy plotshape -supertrend cross under is referred as Sell plotshape -keep stoploss at dot line of supertrend -adx-dmi crossover (+dmi crossed above -dmi) is shown by Triangle Up symbol -adx-dmi crossunder( -dmi crosses below +dmi) is shown by Triangle down symbol --Cross symbol with blue line with linewidth 2 is referred as Take profit --combine this with adx -dmi setting with 7 and 14 ----disclaimer----- used free built in supertrend and adx so u can use same setting in other broker or in trading view not responsible for any loss or gain -only for educational purpose

Supertrend MTF Heikin Ashi This is non-repaiting Supertrend Multi Time Frame script, uses Heikin Ashi Candles as source on normal chart There is an option for Higher Time Frame. if you choose "Auto" then Higher Time Frame calculation is made by the script. If you choose "User Defined" option and then you can select Time Frame. You better use this script with other indicators such as RSI, Momentum etc. Enjoy!