Impulse+

This setup should only be used for long trades and not short trades.
This setup includes trend analysis using 4 EMA lines, volatility range using Keltner Channels, momentum on each bar using MACD and 10 EMA and also helps managing risk on each trade by calculating the max quantity for the max risk specified in the settings. Each of the above is described in detail below:
Trend Analysis
This indicator displays 4 EMA lines (10, 20, 50 and 200). These lines can serve as an indicator to gauge the trend of the stock.
Volatility Analysis
This setup also includes Keltner Channels using ATR 14 and 20 EMA with a multiplier of 2. Widening channel indicates an increase in volatility and vice versa.
Momentum Analysis
Momentum is calculated on each bar and are according color coded. The bar can have 3 possible colors. Aqua / Green indicates a bullish momentum. Gray indicates sideways momentum and Red indicates a bearish momentum.
The momentum is derived by using MACD and EMA 10.
If the EMA 10, MACD and MACD Histogram have a positive slope, the bar is colored green indicating a bullish momentum. While if all the 3 have a negative slope, the bar is colored red indicating a bearish momentum. However if there is a mismatch in the slope of the 3 entities, the bars are colored gray indicating sideways movement.
Risk Management
This indicator takes max risk per trade as one of the settings parameters. Based on this, the indicator calculates the maximum quantity to be purchased for different stop loss values. Also as a utility, the indicator also displays target on a 1:3 risk reward ratio.
A table is displayed at the bottom right of the chart which displays the possible stop loss and their corresponding quantity.
The stop losses considered are EMA 10, EMA 20, EMA 50, EMA 200, Keltner Channel Top, Keltner Channel Bottom, 1 Candle Low, 1 Candle Mid and 2 Candle Low.
These stop losses are only indicative and should be followed as per risk appetite of the consumer.
The trade setup is primarily built for daily timeframe, however the same logic can be applied to other time frames as well. The indicator follows the chart timeframe.
- Added Monthly Pivot Points to the chart.
- Added Target Factor in Inputs
- Added Pivot Points to the Risk Table
Script que requiere invitación
Solo los usuarios autorizados por el autor pueden acceder a este script. Tendrá que solicitar y obtener permiso para utilizarlo. Normalmente se concede previo pago. Para obtener más información, siga las instrucciones del autor o póngase en contacto directamente con alvarajath.
TradingView NO recomienda pagar o utilizar un script a menos que confíe plenamente en su autor y entienda cómo funciona. También puede encontrar alternativas gratuitas de código abierto en nuestros scripts de la comunidad.
Instrucciones del autor
Advertencia: antes de solicitar acceso, lea nuestra guía relacionada con los scripts que requieren invitación.
Exención de responsabilidad
Script que requiere invitación
Solo los usuarios autorizados por el autor pueden acceder a este script. Tendrá que solicitar y obtener permiso para utilizarlo. Normalmente se concede previo pago. Para obtener más información, siga las instrucciones del autor o póngase en contacto directamente con alvarajath.
TradingView NO recomienda pagar o utilizar un script a menos que confíe plenamente en su autor y entienda cómo funciona. También puede encontrar alternativas gratuitas de código abierto en nuestros scripts de la comunidad.
Instrucciones del autor
Advertencia: antes de solicitar acceso, lea nuestra guía relacionada con los scripts que requieren invitación.